Ethernet/Ip And Modbus Tcp Interface - Mettler Toledo IND560 Guia De Instalacion

IND560 Installation Manual
Pin assignments for the PROFIBUS interface are shown in Figure 2-44.
Follow the wiring instructions included with the connector to terminate the wires.

EtherNet/IP and Modbus TCP Interface

The EtherNet/IP Module (Figure 2-45) connects to the network via a standard
Ethernet patch cable. The module's address is set in software, and the DIP
switches are not used and must all be set to OFF.
Figure 2-46 shows the array of status indicator LEDs on the EtherNet/IP card.
2-28
Figure 2-43: PROFIBUS Option Board, Panel Mount Enclosure
PIN SIGNAL
1 Not used
2 Not used
3 RxD/TxD +
4 RTS
5 GND bus
6 +5V bus
7 Not used
8 RxD/TxD -
9 Not used
Figure 2-44: PROFIBUS Nine-Pin Connector Assignments
Figure 2-45: Ethernet / IP Option Board
NOTES:
1. USE MATING CONNECTORS AND CABLE
RECOMMENDED FOR PROFIBUS CONNECTIONS.
2. REFER TO PROFIBUS INTERNATIONAL
DOCUMENTATION FOR OTHER CONSIDERATIONS.