Ethernet / Ip And Modbus Tcp Interface - Mettler Toledo IND780 Guia De Instalacion

2.8.5.

Ethernet / IP and Modbus TCP Interface

The Ethernet / IP Module (Figure 2-99) connects to the network via a standard Ethernet patch cable.
The module's address is set in software, and the DIP switches indicated in Figure 2-99 are not
used and must all be set to OFF.
Note: For use in a Modbus TCP network, the module must be version 1.32 or higher.
Figure 2-100 shows the array of status indicator LEDs on the Ethernet / IP card (see also Figure
2-99).
64057253 | 14 | 08/2014
RJ-45
Connector
DIP Switches for MAC ID (not
used, must be set to OFF)
Figure 2-99: Ethernet / IP PLC Module Components
Link Activity
Activity
Figure 2-100: Ethernet / IP Status Indicator LEDs
LED Status
Indicators
1 2
Module Status
4 3
Network Status
METTLER TOLEDO IND780 Installation Guide
2-63