Publicidad
Idiomas disponibles
Idiomas disponibles
8 | Setup and installation
Anti-tilt device
Anti-tilt device is supplied as an accessory by the AHT
installation service.
Fig. 7: Anti-tilt device
Device-specific anti-tilt device
Possible variants
Fig. 8: Device-specific anti-tilt device
Install display shelves
Responsibility: Operating companies
CAUTION
Improper installation of the display
shelves.
Risk of injury due to falling of the display
shelves holding goods.
▪ The brackets for display shelves must snap
completely into the openings provided
when being attached.
NOTICE
Material damage due to deformation of the
display shelves.
▪ Align the brackets in parallel.
▪ Align the display shelves horizontally.
Material damage due to loss of stability of the
appliance.
Deformation of the display shelves.
▪ Install the appliance rear panel correctly with dis-
play shelves.
▪ The appliance side panel and side display shelf
must be present.
▪ Correctly attach the brackets to the appliance rear
panel.
▪ Insert the display shelves at the same height.
42 / 671
Install display shelves
1. Attach the brackets for the display shelves to the
openings in the rear panel.
Fig. 9: Attach bracket (1) to openings in rear panel (2)
2. Attach display shelves to opening in brackets.
Fig. 10: Attach display shelf (1) to bracket (2)
Number and position of display shelves
–
See → Loading: Loading specification drawing.
For hygiene reasons, do not stick any advertising films
or other materials onto the appliance.
8.1 Electrical connection
The connection to the power supply is carried out by
qualified staff.
For technical data, see →Technical data
Fig. 11:
WARNING
Connect the appliance to the power
supply.
Contact with live parts may result in electric
shock. Fire hazard due to sparking or overload.
Only qualified staff may carry out work on the
electrical system.
▪ Note the following before connecting to the
power supply:
‐
Applicable local electrical safety regulations.
‐
Applicable standards and safety instructions.
‐
Information on the rating plate (see
→Rating plate and serial number).
‐
The mains voltage and mains frequency
must match the specifications on the rating
plate.
▪ Do not connect a damaged appliance or
damaged parts (such as connecting ca-
bles) to the power supply.
▪ Only qualified staff may replace damaged
parts, e.g. connecting cables.
▪ Do not squeeze or bend connecting cables.
▪ Adhere to minimum requirements for con-
necting cables (see →Technical data).
AHT Cooling Systems GmbH | en
369779_1_1019
Publicidad
Capítulos
