Product-Dependent Symbols; Symbols On The Product; Product Information; Declaration Of Conformity - Hilti DCH 300 Manual De Instrucciones

1.3
1.3.1
The following symbols are used on the product:
1.4
Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be informed of any particular hazards that may be
encountered. The product and its ancillary equipment can present hazards if used incorrectly by untrained
personnel or if used not in accordance with the intended use.
The type designation and serial number are stated on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.

Product information

Diamond cutter
Generation
Serial no.
1.5
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2
2.1
WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
▶ Keep work area clean and well lit. Cluttered or dark areas invite accidents.
▶ Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes.
▶ Keep children and bystanders away while operating a power tool. Distractions can cause you to lose
control.
*2149874*
Printed: 23.10.2018 | Doc-Nr: PUB / 5459191 / 000 / 00

Product-dependent symbols

Symbols on the product

Protection class II (double-insulated)
Diameter
Rated speed
Revolutions per minute
Alternating current
Wireless communication
Wear eye protection
Product information

Declaration of conformity

Safety

General power tool safety warnings

2149874
DCH 300 | DCH 300–X
01
English 19