Service Indicator; Depth Gauge; Technical Data - Hilti DCH 300 Manual De Instrucciones

DCH 300
Do not use the product for cutting with water.
3.5
The starting current drawn by the power tool is several times higher than its rated current. The electronic
starting current limiter reduces the starting current drawn by the power tool and thus prevents the mains
fuse blowing. It also allows the power tool to start smoothly, without a jolt.
3.6
The diamond cutter does not restart by itself after an interruption in the electric supply. The on/off switch
must first be released and then pressed again after approx. 1 second.
3.7
The cutter is equipped with an electronic overload protection system that monitors current input.
If the current drawn by the motor is too high, e.g. due to application of excessive pressure by the user, the
electronic overload protection system switches the power tool off.
To switch the power tool on again, release the on/off switch and then press it again.
3.8
The diamond cutter is equipped with a visual (LED) service indicator.
Status
The service indicator lights red.
The service indicator blinks red.
3.9
The desired maximum cutting depth can be set with the aid of the cutting depth scale on the depth gauge.
The depth gauge also improves dust removal performance.
3.10
Diamond cutter with hood, depth gauge (only DCH 300­X), Ø 41 mm clamping flange, M14 clamping nut,
24 / 10 mm AF wrench, 6 mm AF hex key, Operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com
4
4.1
*2149874*
Printed: 23.10.2018 | Doc-Nr: PUB / 5459191 / 000 / 00
Starting current limitation
Restart interlock
Electronic overload protection
The user should aim to work continuously with the tool without activation of the automatic cut-out.
The user can prevent activation of this automatic cut-out by reducing the pressure applied to the tool.

Service indicator

Depth gauge

The depth gauge is not one of the items supplied with the DCH 300 diamond cutter, but it is available
as a retrofit (accessory).
Items supplied

Technical data

Technical data
For rated voltage, rated current, frequency and/or input power, refer to the country-specific type
identification plate.
2149874
Meaning
• End of service interval – servicing is due. After
the LED lights for the first time, the diamond
cutter can continue to be used for several hours
(running time) before the automatic cut-out is
activated.
Return the product to Hilti Service for servicing
•
in good time in order to ensure that it is always
ready for use.
• The product is defective. Have the product
repaired by Hilti Service.
English 25