Configure The Control-Panel Settings - HP 9250C Digital Sender Guía De Instalación Inicial

Connect the power cord
2
1
1. Connect the power cord to the device and outlet.
2. Turn on the power switch and follow the prompts on the control panel.

Configure the control-panel settings

Basic default settings
Language settings
After the device warms up, the messages on the control panel appear in English. Change the language
in one of two ways:
●
Select the preferred language from the Language menu the first time the device is turned on. The
language must be selected within 60 seconds after the menu appears.
or
●
Change the language at any time from the Administration menu. First touch Device Behavior,
touch Language, touch the preferred language, and then touch Save.
Date and time settings
Touch Exit if the date and time settings are correct. Touch OK to change these settings.
Assign the IP address
The device must be assigned a valid IP (Internet Protocol) address on the network. If the network uses
dynamic host configuration protocol (DHCP), the IP address can be assigned automatically. DHCP is
the default setting in the digital sender. Manually assign an IP address if DHCP is not being used.
Find the automatically assigned DHCP IP address
On the home screen, touch Network Address. The IP address appears on the Network Address screen.
If the Network Address button does not appear, find the IP address:
●
Touch Administration, and then touch Information.
● Touch Configuration/Status Pages, and then touch Configuration Page.
●
Touch Show. The digital-sender configuration information appears.
● Touch OK to see the Jetdirect data. Scroll through the information to find the IP address.
ENWW Configure the control-panel settings 5