Husqvarna P 535HX Manual De Usuario página 27

a) For the Combi cutting deck:
A
B
b) For the R180 cutting deck:
B
A
7. Remove the 2 screws and remove the service hatch.
8. Pull back the coupling of the drive shaft and attach
the drive shaft to the PTO shaft on the product.
Note:
Make sure that the arrow on the symbol
points to the product.
1591 - 001 - 21.12.2020
A
B
B
A
9. Put the rear lock chain around the lift beam.
10. Attach the rear lock chain to the drive shaft.
11. Pull back the coupling of the drive shaft and attach
the drive shaft to the bevel gear shaft of the cutting
deck.
12. Fold the rubber casing onto the shaft joint.
13. Put the front lock chain around the pipe.
14. Attach the front lock chain to the drive shaft.
15. Attach the service hatch and tighten the screws.
16. Start the electrical drive. Refer to
product on page 33 .
17. Move the lever for the hydraulic lift arms rearward to
lift the cutting deck. Lift until the pivot wheels of the
cutting deck do not touch the ground.
18. Apply the parking brake.
19. Turn the power key to the STOP position.
20. Attach the lifting eyes.
To start the
27