Replace The Blades; Do A Check Of The Parallelism Of The Cutting Deck - Husqvarna P 535HX Manual De Usuario

2. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
3. Tighten the blade bolts with tightening torque
(8.15-8.56 kpm / 59-62 lbft) 80-84 Nm.
To replace the blades
1. Put the cutting deck in servicing position.
2. Lock the blade with a wooden block (A).
C
3. Loosen and remove the blade bolt (B), the washers
(C) and the blade (D).
4. Assemble the new blade with the ends that have an
angle in the direction of the cutting deck.
WARNING:
can cause objects to eject from the
cutting deck and cause serious injury.
Use only the blades given in
data on page 64 .
5. Attach the blade, the washer and the bolt. Tighten
the bolt with a torque of (8.15-8.56 kpm / 59-62 lbft)
80-84 Nm.
To do a check of the oil level in the bevel gear
of the cutting deck
1. Park the product on a level surface.
2. Lower the cutting deck to mow position.
1591 - 001 - 21.12.2020
B
D
A
Incorrect blade type
Technical
3. Put a clean metal rod into the gear housing. The
metal rod must be a minimum of 100 mm long and
maximum 3 mm in diameter.
4. Lower the metal rod to the bottom of the gear
housing.
5. Pull the metal rod out and read the oil level.
6. Measure the part of the metal rod that has oil on it.
There must be oil on 15 mm of the metal rod.
7. Fill with gearbox oil if the oil level is less than 15 mm
of the metal rod. Refer to
64 for recommended oil.
To replace the oil in the bevel gear of the
cutting deck
1. Remove the cutting deck. Refer to
cutting deck on page 28 .
2. Put the cutting deck on its front edge and drain the
oil through the oil fill plug.
3. Let the oil run out into a container.
4. Fill with 80 ml new hydraulic oil as given in
data on page 64 .
To do a check of the parallelism of the cutting
deck
1. Do a check of the air pressure in the tires. Refer to
Tire pressure on page 51 .
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck.
Technical data on page
To remove the
Technical
53