Cutting Deck - C132, C155; To Examine The - Husqvarna P 535HX Manual De Usuario

Cutting deck - C132, C155

To put the cutting deck in servicing position
1. Do the procedure in
page 28 but do not disconnect the lift arms.
2. Remove the service stay from the cutting deck.
WARNING:
and the safety straps when the cutting
deck is in servicing position. To not use
the service stay or safety straps correctly
can result in serious injury or death.
3. Attach the service stay to the red point below the
bottom plate.
4. Pull the pin on the other end of the service stay.
Attach the service stay to the red mark on the pipe
on the cutting deck.
5. Start the engine.
6. Move the lever for the hydraulic lift arms rearward to
lift the cutting deck fully.
52
To remove the cutting deck on
Attach the service stay
7. Attach 1 end of the safety straps around the pipe
adjacent to the steering column (A).
B
8. Attach the other end of the safety strap around the
pivoting wheels of the cutting deck (B).
9. To put the cutting deck in mow position, follow the
instructions in the opposite sequence.
To remove and attach the BioClip
1. Put the cutting deck in servicing position.
2. Remove the 3 screws that hold the BioClip
and remove the plug.
3. Attach 3 M8x15 mm screws in the screw holes for
®
the BioClip plug to prevent damage to the threads.
4. Put the cutting deck in mow position.
®
5. Attach the BioClip
To examine the blades
CAUTION:
balanced blades can cause damage to the
product. Replace damaged blades. Let an
approved service agent help you sharpen
and balance blunt blades.
1. Put the cutting deck in servicing position.
A
®
plug
®
plug in the opposite sequence.
Damaged or incorrectly
1591 - 001 - 21.12.2020
plug