Cutting Deck - R180 - Husqvarna P 535HX Manual De Usuario

a) Combi 155 must be measured in 2 areas. Make
sure that the rear edge is 6–9 mm (1/4 - 3/8 in.)
higher than the front edge.
b) Combi 155 X must be measured in 4 areas.
Make sure that the rear edge is 6–9 mm (1/4 -
3/8 in.) higher than the front edge.
To adjust the parallelism of the cutting deck
1. Turn the track rod to extend it or make it shorter.
Extend the track rod to lift the rear edge of the cover.
Make the track rod shorter to lower the rear edge of
the cover.
2. Tighten the nuts on the track rod.
3. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
53 .
4. Attach the front cover.
54
To replace the belt on the cutting deck
1. Remove the 3 screws that hold the belt cover.
2. Remove the belt cover.
3. Attach the service stay to the tension spring.
4. Push the service stay and remove the belt.
5. Attach the belt around the pulleys as shown in the
illustration.

Cutting deck - R180

To examine the blades
1. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
2. Tighten the blade bolts with tightening torque 125
Nm (12.75 kpm / 92 lbft).
To replace the blades
1. Lock the blade with a wooden block (A).
To do a
WARNING:
incorrectly balanced blades can
cause damage to the product.
Replace damaged blades. Let an
approved service agent help you
sharpen and balance blunt blades.
C
1591 - 001 - 21.12.2020
Damaged or
B
D
A