Product Data; Technical Data; Scope Of Delivery - salmson ALTI-NEXIS-V Manual De Instrucciones

The pipes will not withstand loads and should
not be used to secure loads in transit. Some stik-
kers on manifolds reminds this advice (Fig. 2b).
ATTENTION! Loading the pipes in transit can result
in leaks.
• When the product is delivered, check it for any dam-
age in transit. If any defect is found, inform the
delivery company (forwarding agent).
The pumps transport lock (if equipped) should be
removed before the start o the pump (sticker Fig. 2c,
2d).
ATTENTION! If the product is installed later on,
store it in a dry place. Protect it from impacts and
any outside influences (moisture, frost, etc. ...).
Handle the product with care.
4. Application
The booster is designed for boosting and maintaining
the pressure when the water supply network is not
well dimensioned or does not exist.
When a speed converter is integrated in the pumps,
the electronic regulation system integrated in the
control unit allows to get a constant pressure in the
water supply network whatever the flow is.
The booster is either or supplied:
- On load: from the public water mains or from a
mains collection tank.
- On suction: (on demand).
POMPES SALMSON SAS 01/2012

5. Product data

5.1 Type key
ALTI-NEXIS-V 2205 / 2-5,5/K/2-CC-16-T4-FC-03
ALTI = Standard version
NEXIS = Pump type
V = vertical
VE = electronic pump
22 = Nominal flow (m 3 /h)
05 = Number of stages
Total number of impellers/
pumps
Motor power when there is 2
motor powers for the same
number of pump stages
Pump with cartrige
Operating mode of the
boosting system:
2 = 2 pumps in cascade
3 = 3 pumps in cascade
4 = pumps in cascade
Control unit:
NO: Without
CE: electronic control
CC: automation control
CVV: control for electronic pump
Max. operating pressure
Three-phase 400V
Frequency converter (variant)
Variant of construction:
03: Manifolds Stainless steel 304 –
assembling glued
04: Manifolds Stainless steel 304 –
assembling in flange
05: Manifolds Stainless steel 304 –
assembling glued – in suction
06: Manifolds Stainless steel 304 –
assembling in flange – in suction

5.2 Technical data

• Max. operating pressure:
• Max. water temperature:
• Max. ambiant temperature:
• Three-phase voltage:

5.3 Scope of delivery

• Booster.
• Control box or cabinet (separate from the booster
set according to the type and power).
• Installation instructions: booster, pump and
automatism.
• Safety instruction.
English
16 or 25 bars
+70 °C
+40 °C
50 Hz 230/400V
60 Hz 220/380V –
230/400V (option)
19