Checks; Chimney Sweeper Function - Sime Brava Slim HE 25/55 ErP Manual De Instalación Y Mantenimiento

EN
TABLE OF INFORMATION DISPLAYED
Type No. Description
PAR 00 SW version
PAR 01 External sensor
Delivery sensor
PAR 02
temperature
PAR 03 Smoke probe
Domestic hot water
PAR 04
sensor temperature
PAR 05 AUX auxiliary sensor
Actual heating SET
PAR 06
temperature
PAR 07 Power level
PAR 08 Flow meter rate
Water pressure
PAR 09
transducer reading
Display of current
PAR 10
fan revolutions
TABLE OF COUNTER DISPLAYED
Type No. Description
total no. of boiler
PAR c0
operating hours
total no. of burner
PAR c1
operating hours
total no. of burner
PAR c2
ignitions
PAR c3 total no. faults
total no. of times
PAR c4 installer parameters
"ALL"accessed
total no. of times
PAR c5 OEM parameters
accessed
time unitl next
PAR c6 maintenance
intervention
TABLE OF ACTIVATED ALARMS/FAULTS
Type No. Description
PAR A0 Last activated alarm/fault
PAR A1 Last but one activated alarm/fault
PAR A2 Third from last activated alarm/fault
PAR A3 Previous activated alarm/fault
PAR A4 Previous activated alarm/fault
PAR A5 Previous activated alarm/fault
PAR A6 Previous activated alarm/fault
PAR A7 Previous activated alarm/fault
PAR A8 Previous activated alarm/fault
PAR A9 Previous activated alarm/fault
Range U/M Step
- 9 ..
°C 1
99
- 9 ..
°C 1
99
- 9 ..
°C 1
99
- 9 ..
°C 1
99
- 9 ..
°C 1
99
Par.
13 ...
°C 1
Par.
14
0 ..
% 1
99
0 ..
l/min 0.1
99
0 ..
bar 0.1
99
0 ..
RPM x 100 1
99
Range U/M Step
0.1; from
0 .. 0.0 to 9.9;
h x 1000
99 1; from 10
to 99
0.1; from
0 .. 0.0 to 9.9;
h x 1000
99 1; from 10
to 99
0.1; from
0 .. 0.0 to 9.9;
h x 1000
99 1; from 10
to 99
0 ..
x 1 1
99
0 ..
x 1 1
99
0 ..
x 1 1
99
1 ..
months 1
199
3.7

Checks

3.7.1

Chimney sweeper function

The chimney sweeper function is used by the qualified
maintenance technician to check the mains gas pressure, detect
the combustion parameters and to measure the combustion
efficiency required by legislation in force.
This function lasts 15 minutes and is activated by proceeding
as follows:
– if the panel (2) has not already been removed, remove the
two screws (1), pull the front panel (2) forwards and release it
from the top by lifting it
2
– remove the screws (3) securing the control panel (4)
– move the panel (4) upwards (a) but keeping it in the side
guides (5) to the end of travel
– bring it forwards and down (b) until it is horizontal
4
b
– close the gas valve
– loosen the screw of the "mains pressure" point (6) and connect
a pressure gauge
1
Fig. 35
a
3
Fig. 36
5
91