Connecting The Speakers; Connecting External Equipment - JVC UX-V10 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION: Make all connections before plugging the System into an AC power outlet.

Connecting the Speakers

For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the System.
1. Open each of the terminals and insert the speaker wires firmly, then close the terminals.
2. Connect the red (+) and black (–) wires of the right side speaker to the red (+) and black (–) terminals marked R on the System.
Connect the red (+) and black (–) wires of the left side speaker to the red (+) and black (–) terminals marked L on the System.
CAUTION:
If a TV is installed near the speakers, the picture on the TV may be distorted. If this happens, set the
speakers away from the TV.

Connecting External Equipment

For Hong Kong:
Connect signal cords (not supplied) between the System's LINE IN (AUX)/LINE OUT terminals and the output/input terminals of an
external MD recorder, cassette deck, etc.
You can then listen to the external source through the System, or record the System's CD player, cassette tape, or tuner to the external unit.
For the other areas:
You can connect an audio equipment — used only as a playback device.
Connect the audio output terminals on the other equipment and the LINE IN (AUX) terminals on the rear, using a signal cord (not supplied).
LINE OUT
R
L
LINE IN
(AUX)
Connecting an MD Recorder, etc. (Digital Output)
(For Hong Kong only)
Unplug the cap and connect an optical digital cord (not supplied) between the System's OPTICAL DIGITAL OUT terminal and the input
terminal of an MD recorder, etc.
You can record the digital output signal from the System's CD Player to the MD recorder, etc.
OPTICAL
DIGITAL OUT
4
EN01-09.UX-V10[U]
Right speaker (rear side)
Signal cord (not supplied)
Pin-plug x 2
Pin-plug x 2
Signal cord (not supplied)
Pin-plug x 2
Pin-plug x 2
Cap
Optical digital cord (not supplied)
4
Left speaker (rear side)
Black
L
R
SPEAKERS
IMPEDANCE
MIN 4Ω
To audio input
MD recorder or cassette
deck (not supplied)
To audio output
To optical digital
input
00.4.19, 10:45 AM
For Hong Kong only
MD recorder, etc. (not supplied)

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ux-v10gnUx-v10wtUx-v10gnu

Tabla de contenido