Care And Maintenance - JVC UX-V10 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Care and Maintenance

Handle your CDs carefully, and they will last a long time.
Compact Discs
Only CDs bearing this mark can be used with
this System. However, continued use of
irregular shape CDs (heart-shape, octagonal,
etc.) can damage the System.
Remove the CD from its case by holding it at
the edges while pressing the case's center hole
lightly.
Do not touch the shiny surface of the CD, or
bend the CD.
Put the CD back in its case after use to prevent
warping.
Be careful not to scratch the surface of the CD
when placing it back in the case.
Avoid exposure to direct sunlight, temperature
extremes, and moisture.
A dirty CD may not play correctly. If a CD
does become dirty, wipe it with a soft cloth in a
straight line from center to edge.
CAUTION: Do not use any solvent (for example,
conventional record cleaner, spray thinner,
benzine, etc.) to clean a CD.
General Notes
In general, you will have the best performance by keeping your
CDs and the mechanism clean.
Store CDs in their cases, and keep them in cabinets or on
shelves.
Keep the system's CD cover closed when not in use.
Cleaning the Lens
If the lens in the CD pickup is dirty, sound degradation may take
place.
Open the CD cover and clean the lens as shown.
Use a blower (available from a camera store) to blow dust off
the lens.
20
EN10-22.UX-V10[U]
Blower
Lens
20
If there are fingerprints, etc. on the lens, gently wipe clean with
a cotton swab.
Moisture Condensation
Moisture may condense on the lens inside the
System in the following cases:
After turning on heating in the room
In a damp room
If the System is brought directly from a cold to
a warm place
Should this occur, the System may malfunction. In
this case, leave the System turned on for a few
hours until the moisture evaporates, unplug the AC
power cord, and then plug it in again.
Cassette Tapes
If the tape is loose, it may get stretched, cut, or
caught in the cassette. Take up the slack by
inserting a pencil in one of the reels and
rotating.
Do not touch the tape surface.
Do not store the tape:
-
In dusty places
-
In direct sunlight or heat
-
In moist areas
-
On a TV or speaker
-
Near a magnet
Cassette Deck
If the heads, capstans, or pinch-rollers of the Cassette Deck
become dirty, the following may occur:
-
Loss of sound quality
-
Discontinuous sound
-
Fading
-
Incomplete erasure
-
Difficulty in recording
Clean the heads, capstans, and pinch-rollers using a cotton
swab moistened with alcohol.
Capstans
Erase head
If the heads become magnetized, the Unit will produce noise or
lose high frequency notes.
To demagnetize the heads, turn off the Unit, and use a head
demagnetizer (available at electronics and record shops).
00.4.19, 10:48 AM
Pinch-rollers
Record/play head

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ux-v10gnUx-v10wtUx-v10gnu

Tabla de contenido