TOHATSU MFS 6BZ Manual Del Propietário página 70

68
INSPECTION AND MAINTENANCE
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn
past finger-tight. Have the oil filter
adjusted to the correct torque as soon as
possible with a torque-wrench.
7. Reset the engine in a vertical posi-
tion.
8. Repeat 3 to 7 procedures two or
three times to drain the oil com-
pletely.
9. Remove the top cowl and the oil
filler cap.
10. Fill the engine through filler port
with recommended oil (see char t
below) to the middle of dipstick
mark.
11. Tighten the oil filler cap.
1
10
3
1. Filler cap
2. Dipstick
3. Filler port
1. Upper limit (Max.)
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 13)
-30
-22
Oil volume needed for complete oil replacement
With oil filter replace-
ENOW00925-0
2
Wipe off engine oil well imme diately if
ENOF01423-0
spilled and dispose of it in accordance with
local fire prevention and environment pro-
tection regulations.
ENON00031-0
Note
1
2
10W−40
10W−30
-20 -10 0 10 20
-4 14 32 50 68
Without oil filter
ment
800 mL(27 fl.oz.)
CAUTION
If any amount of water is found in
engine oil, making it milky white, con-
sult dealer.
ENOF00113-0
30 40 ˚C
86 96 ˚F
ENOF00208-0
replacement