Maintaining The Printer; Cleaning The Media System And Maintenance Cover - Epson SureColor S Serie Guía De Referencia Rápida

Select and press
Proceed
6.
Select a cleaning level and press
7.
Print a nozzle pattern and check the results to determine whether the head cleaning was successful.
8.
If you cannot recover all nozzles by running the heaviest cleaning cycle, you need to wash the ink system,
as described on page 26.

Maintaining the Printer

You should regularly check the ink status and replace cartridges (see page 24) as necessary. For the
S50675/S70675, the printer performs automatic maintenance to prevent ink accumulating and causing
clogs. Do not turn the printer off, or this maintenance will not be performed.
Periodically, you also must perform the following maintenance procedures:
Procedure
Clean the media system and maintenance cover
Remove and shake ink cartridges
Wash the print head
Clean the print head, wiper, caps, wiper rail
Dispose of waste ink
Replace the wiper, wiper cleaner, and ink flushing pad

Cleaning the Media System and Maintenance Cover

To remove ink and particles of paper, clean the platen heater, pressure rollers, media holding plates, and
inside left maintenance cover before starting work each day.
Make sure the printer is turned off.
1.
Wait a minute, then open the front cover.
2.
.
OK
.
OK
Maintaining the Printer
Frequency
Daily
Daily
As needed
Daily or more often if needed
As needed
Every 3 months or as needed
|
21
Instructions
below
page 25
page 26
page 26,
page 29
page 34
page 36