Description Of Control Lever Controls (Trolley Version) - SICE S 60 Uso Y Mantenimiento

DESCRIPTION OF CONTROL LEVER CON-
TROLS (TROLLEY version)
Four-position joystick (A fig. 13)
With horizontal movement it con-
trols turntable spindle holder
structure right/left transfer.
With vertical movement it controls
turntable spindle holder arm
upstroke/downstroke.
Two-position joystick (B fig. 13)
With horizontal movement it con-
trols the tool carriage right/left
transfer.
On/off button (C fig. 13)
If pressed together with the turn-
table spindle holder structure
transfer, or with the tool carriage
transfer, it activates the high speed transfer control. The transfer high speed control
must be used only in the approaching steps. During the high speed approaching steps
the turntable spindle rotation control is disabled for safety reasons.
Four-position joystick (D fig. 13)
With the horizontal movement it drives the tool unit clockwise and counter clockwise
rotation.
With vertical movement it controls the upward/downward movement of the tool arm.
insist onto the control to make sure the two arm blocking ratchets are completely
hooked in the working position (fig. 13)
Three-position lever (central zero) (E fig. 13)
With vertical movement it controls the opening and closing of turntable spindle.
Three-position lever (F fig. 13)
It adjusts the turntable spindle speed.
With lever in maximum speed position the turntable will rotate at 10 rpm.
With lever in intermediate speed position the turntable will rotate at 6 rpm.
With lever in minimum speed position the turntable will rotate at 4 rpm.
With lever in minimum speed position, it is possible to further reduce the revolutions
per minute to obtain the optimal speed for the tread design. This further speed re-
duction, occurs only by rotating the turntable clockwise.
78
CAUTION!
13
User Manual S60