Charging The Power Supply Battery; Description Of Control Lever Controls (Control Arm) - SICE S 60 Uso Y Mantenimiento

Except for a brief period during the initial test cycle for all three LEDs, the green and
red LEDs are never lit simultaneously.

CHARGING THE POWER SUPPLY BATTERY

Perform the following operations to completely recharge the battery:
1. Plug in the battery charger to the 220 V mains socket
2. Insert the bipolar plug connector in the socket placed on the side of the lever control
3. Wait for the battery to be charged with the connected battery charger (4/5 hours
if completely flat)
4. Disconnect the battery charger from the mains and from the control lever.
DESCRIPTION OF CONTROL LEVER
CONTROLS (CONTROL ARM)
Four-position joystick (A fig. 13)
With horizontal movement it controls
turntable spindle holder structure
clockwise and counter clockwise
rotation.
With vertical movement it controls
the upward/downward movement of
the tool arm.
CAUTION!
insist onto the control to make
sure the two arm blocking rat-
chets are completely hooked in
the working position (fig. 13)
Four-position joystick (B fig. 13)
With horizontal movement it controls the tool carriage right/left transfer. With vertical
movement it controls turntable spindle holder arm upstroke/downstroke.
On/off button (C fig. 13)
If pressed together with the turntable spindle holder structure transfer, or with the
tool carriage transfer, it activates the high speed transfer control. The transfer high
speed control must be used only in the approaching steps. During the high speed ap-
proaching steps the turntable spindle rotation control is disabled for safety reasons.
Four-position joystick (D fig. 13)
With the vertical movement it drives the tool unit clockwise and counter clockwise
rotation.
With horizontal movement it controls turntable spindle holder structure right/left transfer.
Three-position lever (central zero) (E fig. 13)
80
13
User Manual S60