Definitions Of Indicators In The Display; Pointgard 2100 Ec-Specific; Control Panel; Info Mode And Function Key - Dräger PointGard 2000 Serie Instrucciones De Uso

7.3 Definitions of indicators in the
display
Symbol Explanation
Error message available.
Warning message available.
Maintenance signal is transmitted.
Measuring range of analog interface
exceeded.
Measurement value less than range of
analog interface.
Analog interface is set to a fixed value and
is not transmitting any measurement sig-
nal.
SIL SIL is activated. The instrument is not SIL-
certified. SIL functions are therefore not
supported, however the symbol can
appear.

7.3.1 PointGard 2100 EC-specific:

Symbol Explanation
"Preventive" maintenance: The sensor is
ready for operation.
"Preventive" maintenance: The sensor is
ready for operation but is close to the end
of its life cycle.
"Preventive" maintenance: The sensor is
still ready for operation but should be
changed as soon as possible.
The data logger is active in Roll mode.
The data logger is active in stack mode.
7.4

Control panel

Button Function

Upwards / Function key
Downwards / Menu key
M
Different functions depending on the type of menu
OK
7.5

Info mode and function key

7.5.1 Activating info mode

The Info mode is used to show instrument relevant
information. This does not interrupt the normal operation of
the instrument.
● Tap and hold for 3 seconds in measuring mode.
Instructions for use |
Dräger PointGard 2000 Series

7.5.2 Info mode navigation

Button Function
Switches to the next screen
Switches to the previous screen
M
Ends info mode
OK
If no key is tapped within 30 seconds, the instrument will
automatically return to normal operation.

7.5.3 Using function key

Using the function key, a pre-set function can be executed. By
default the faults are displayed.
● Tap and hold for 1 seconds in measuring mode.
To configure the function key, see 11.4 Configuring function
key.
7.6

Menu

7.6.1 Menu navigation

Button Function
Scrolls upwards.
Sets values.
Scrolls downwards.
M
Sets values.
Confirms entry.
OK
Selects menus and functions.

7.6.2 Passwords

Calibration Access to information (Information menu)
PWD and calibration settings (Calibration
menu)
Default: _ _ _ 1
Settings PWD Access to all configurations and menus
Default: _ _ _ 2
To change passwords, see 11.1.

7.6.3 Entering the menu

● To directly enter the Information menu:
a. Tap and hold for 1 second in the measuring mode.
M
● To enter the Calibration menu:
a. Tap and hold for 3 seconds in measuring mode
M
b. Select Enter password
c. Enter Calibration PWD.
● To enter all menus:
a. Tap and hold for 3 seconds in measuring mode
M
b. Select Enter password
c. Enter Settings PWD
|
Operation en
15