GASPARDO FIORE Empleo Y Mantenimiento - Piezas De Repuesto página 41

EVERY 8 WORK HOURS
- Grease the cardan shaft cross journals.
- Adjust belt tension periodically by adjusting nut (G, Fig. 34).
Check tension via the viewing panel on the belt guard. Belt slack
must not exceed 2 cm. It is essential to close the inspection hatch
with the relative lid after the belts have been examined.
EVERY 50 WORK HOURS
- Check the tightness of the connecting rod bolts regularly (Fig.
35).
PERIODICALLY (6 MONTHS)
- Grease point (A-B-C, Fig. 32).
AFTER EACH MOWING JOB
- Clean and oil the mowing bar blades according to the in-
structions in the chapter entitled: "Cleaning and oiling the
cutters".
CLEANING AND OILING THE CUTTERS
Mowing bar cleaning and oiling are very dangerous poerations.
Always comply with the following instructions:
- Lift the implement by means of the lift links in a À at place where
it cannot slip;
- Operate the mowing bar, checking that there are no persons or
animals in the vicinity;
- Brake the tractor and make sure it is unable to move;
- Wash the mowing bar with a jet of pressurized water, stan-
ding at least one and a half meters away from the imple-
ment;
- Switch off the tractor, remove the starter key and disengage the
pto;
- Check the condition of the cutters;
- When the mowing bar is dry, lubricate the cutting blades
with very viscous oil;
- Operate the mowing bar for a few seconds, cheking that there
are no persons or animals in the vicinity;
- Switch off the tractor, remove the starter key and disengage the
pto;
- Fit the guards over the cutters and outer skid (C, Fig. 36)
IMPORTANT: The cutting blades must be cleaned and lubri-
cated every day after work.
STORAGE
It is advisable to proceed in the following way at the end of the
season or if the machine is to remain inactive for a long period of
time:
- Treat the implement in compliance with the instructions given in
the chapter entitled: "Cleaning and oiling the cutters".
- Carefully check for any damaged or worn parts and replace
these as necessary.
- Fully torque all screws and bolts.
- Apply a little lubricant to the unpainted parts.
- Protect the entire implement with a tarpaulin.
- Lastly, store the implement in a dry place where it cannot be
tampered with by unauthorized persons; the mowing machi-
ne must be set-up on fl at and compact ground, supported
by the relative bearing struts (H-I, Fig. 37).
Careful compliance with these instructions will be all to the
advantage of the user who will be sure to use an implement
in perfect conditions when work begins again.
cod. G19503900
DANGER
-
USE AND MAINTENANCE
G
Fig.36
Fig.37
ENGLISH
Fig. 34
Fig. 35
C
H
I
41