Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.0.2 SETTING-UP THE MOWING MACHINE
For transport requirements, the mowers are sent with the cutting
unit removed from the frame.
After the two parts have been put back together, it is important
to check carefully that all the screws are tightened correctly (Fig.
12) after the ¿ rst 4 to 6 hours of work. Check again after 25 to 30
hours. A careful periodical check that the screws are tight will help
to avoid unwelcome problems and breaks.
The mowing machine must be set-up on À at and compact ground,
supported by the relative bearing struts (C-D, Fig. 13).
3.0.3 HITCHING TO THE TRACTOR
The mower can be hitched to any tractor equipped with a universal
three-point coupling.
Application of any implement to a tractor is a very dange-
rous operation and must only be carried out with the utmost
care in compliance with the instructions.
The correct tractor/mower position is established by setting the
implement at such a distance from the tractor that the universal
coupling remains 5-10 cm from its maximum closing position.
Now proceed in the following way:
1) Hook the oscillating arms of the tractor to pins (G and H, Fig.
14).
The hoisting arm (O, Fig. 15) must be ¿ xed underneath the
tractor arm. Lock in place with the snap-in split pins.
2) Connect the upper third-point and correctly regulate by means
of the adjuster (E, Fig. 14). Place plate (F, Fig.14) at the left side
of the hicht integral with the same pin. Lock in place with the
snap-in split pins.
3) Lock the lift links using the relative chains (I, Fig. 14) and cou-
plings parallel to the tractor. This operation must be carried out
to prevent the machine from moving in a horizzontal direction.
4) Engage the cardan shaft and check that it is perfectly locked on
the pto. Check that the guard is free to turn and ¿ x it with the
relative latch (Fig. 16).
cod. G19503900
DANGER
-
USE AND MAINTENANCE
Fig. 13
F
I
G
Fig. 14
Fig. 15
Fig. 16
ENGLISH
C
D
E
H
O
35
Publicidad
Tabla de contenido
