Description Of The Mower; Technical Data - GASPARDO FIORE Empleo Y Mantenimiento - Piezas De Repuesto

ENGLISH

1.3 DESCRIPTION OF THE MOWER

This agricultural implement can only operate by means of a cardan
shaft applied to the pto of an agricultural tractor equipped with lift
and universal three-point hitch.
Since it is movable, the mowing machina can be easily mounted on
tractors with different gauges or on tracked vehicles (Fig. 2).
The two-motion tooth-blade system used in mowing machines,
makes possible a scissors cut which leads to a higt speed ope-
ration on a any crop.
The original tooth-blade motion guarantees a sharp and clean cut
on any type of grass, be it damp or À attened. It is thanks to the total
absence of soil which this mowing system does not raise, sharp
because the stems are not frayed.
The mower may also be used with the cutting arm tilted for working
on canals, ditches, embankments. (Fig. 3 and 4).
The lifting system of the mowing bar can be mechanical or hydraulic
according to choice. In this manual instructions are given for the
mechanical system only.
To install and use the hydraulic system refer to the manual (code
G19503040) supplied with the accessory. The manual must be
kept in a safe place so that it can be referred to during the whole
of the machine's operating life.
ATTENTION
The mower is suitable only for the uses indicated. Any other
use different from that described in these instructions could
cause damage to the machine and represent a serious hazard
for the user.
It is therefore advisable to strictly comply with the following instruc-
tions in order to prevent faults which could jeopardize the correct
and long-lasting operation of theimplement. Compliance with the
instructions in this handbook is also important since the Manufactu-
rer declines all and every responsibility for damage to persons
or property caused by negligence and failure to comply with
these instructions. The Manufacturer shall, however, remain at
the customers' disposal for immediate and thorough assistance
together with anything else that may be required in order to ensure
the correct operation and maximum ef¿ ciency of the implement.

1.4 TECHNICAL DATA

Cutting arm lenght
Weight
Power take-off revs
Schinitt (max)
Power required
No-load noise detection (*)
(*) L = Acoustic power level uttered by machine (Weighed A);
WA
L = Continuous equivalent acoustic radiation pressure level (Weighed A) in the "worker's position".
pA
The technical data and the models provided must be considered as non binding. We reserve the right to change them without
notice.
28
USE AND MAINTENANCE
Fig. 2
Fig. 3
Fig. 4
U.M.
[m] 1,45
[kg] 222
[g.p.m.]
[Km/h]
[HP - (kw)]
[dB]
-
FBR Plus
1,75 2,05
230 238
540
10÷12
25 - (19)
(L = 110,7) - (L = 91,7)
WA pA
cod. G19503900
2,35
246