Execution Of A Single Or Multi-Wavelength Measurement - Hach SIP 10 Manual Básico Del Usuario

The Pour-Thru Cell cannot be used for the tests listed in
potential problems caused by chemical incompatibility or other
complications. Use the sample cell specified in the procedural
instructions for these tests.
Table 2 Tests for which the Pour-Thru Cell is not suitable
Aluminum ECR Arsenic
Cyanuric Acid Fluoride
Mercury Nickel, Heptoxime
Phenols Potassium
Suspended Solids Sulfate
Zinc Surfactants, Anionic (Detergents)
The Pour-Thru Cell can also be used for other tests. However, please
note that the Pour-Thru Cell requires a minimum sample volume of
25 mL to make sure that the previous solution is fully rinsed out of the
cell. Make sure that you increase the reagent and sample volumes
accordingly.
English 8
Table 2 due to
Barium Boron, Carmine
Formaldehyde Lead, LeadTrak
Nitrite, HR PCB
Selenium Silver
TPH Volatile Acids
Execution of a Single or Multi-Wavelength
Measurement
1. Press SINGLE WAVELENGTH or MULTI-WAVELENGTH.
2. Press OPTIONS to adjust the settings within single/multi-
wavelength mode.
3. Place the feed tube in the zero solution and press ZERO.
The zero solution is sucked in over the selected sip time. Once the
settle time has passed, the zero measurement is taken.
Note: The remaining time is shown on the display. Press CANCEL
to abort the operation.
Note: If the PURGE START: AUTO setting has been activated in
the Sipper options menu, the rinse agent is sucked in automatically
once the measurement process is complete.
The zero measurement is shown on the display.