Af Settings - Danfoss VLT AutomationDrive FC 302 Manual De Funcionamiento

Programación

6.4.7 300-** AF Settings

AVISO!
Except for 300-10 Tensión nominal del filtro activo, it is not recommended to change the settings in this parameter
group for the Low Harmonic Drive
Par. nº # Descripción del parámetro
300-0* General Settings
300-00 Harmonic cancellation mode
300-01 Compensation priority
300-08 Lagging reactive current
6 6
300-1* Network Settings
300-10 Active filter nominal voltage
300-2* CT Settings
300-20 CT primary rating
300-24 CT Sequence
300-25 CT Polarity
300-26 CT Placement
300-27 Number of CTs per phase
300-29 Start auto CT detection
300-3* Compensation
300-30 Compensation points
300-35 Cosphi reference
300-4* Paralleling
300-40 Master follower selection
300-41 Follower ID
300-42 Num. of follower AFs
300-5* Sleep Mode
300-50 Enable sleep mode
300-51 Sleep mode trig source
300-52 Sleep mode wake up trigger
300-53 Sleep mode sleep trigger
112
Manual de funcionamiento
Valor predeterminado
[0] Harmonics
[0] Disabled
ExpressionLimit
ExpressionLimit
[0] L1, L2, L3
[0] Normal
[1] Load Current
[2] Not Paralleled
[0] Mains current
ExpressionLimit
Danfoss A/S © Rev. 07-02-2014 Reservados todos los derechos.
4-set-up (4
ajustes)
[0] Overall All set-ups
All set-ups
All set-ups
2 set-ups
2 set-ups
2 set-ups
2 set-ups
2 set-ups
1 All set-ups
[0] Off All set-ups
0.0 A All set-ups
0.500 N/A All set-ups
2 set-ups
1 N/A 2 set-ups
1 N/A 2 set-ups
null 2 set-ups
All set-ups
All set-ups
80 % All set-ups
Cambio Índice de Tipo
durante conversió
funciona- n
miento
TRUE - Uint8
TRUE - Uint8
FALSE Uint8
FALSE 0 Uint32
FALSE 0 Uint32
FALSE - Uint8
FALSE - Uint8
FALSE - Uint8
FALSE Uint8
FALSE - Uint8
TRUE -1 Uint32
TRUE -3 Uint16
FALSE - Uint8
FALSE 0 Uint32
FALSE 0 Uint32
TRUE - Uint8
TRUE - Uint8
TRUE 0 Uint32
TRUE 0 Uint32
MG37A205