Husqvarna TE125 2011 Caracteristicas - Uso - Mantenimiento página 69

REAR BRAKE PEDAL FREE PLAY ADJUSTMENT
The rear brake pedal (3) should have a free play (B) (0.2
in.) before the brakes begin to bite.
Should this not happen, operate as follows:
- loosen nut (4);
- operate the pump rod (5) to increase or decrease the
free play;
- tighten nut (4) at the end of the operation.
WARNING*:
When the free play requirement is not
met, the brake pads will be subjected
to an early wear that may lead to TOTAL
BRAKE INEFFECTIVENESS.
5
4
EN - 26
REAR BRAKE FLUID LEVEL CHECK
Master cylinder fluid level - visible through sight glass (1)
- must be above the minimum notch on master cylinder
reservoir.
A decrease of the fluid level will let air into the system,
hence an extension of the lever stroke.
1
MIN
WARNING*: If the brake pedal feels
mushy when pulled, there may be air in
B the brake lines or the brake may be de-
fective. Since it is dangerous to operate
the motorcycle under such conditions,
have the brake system immediately
checked by the Husqvarna Dealer.
CAUTION*: Do not spill brake fluid onto
any painted surface or light lens.
3
CAUTION*: Do not mix two brands of flu-
id. Completely change the brake fluid in
the brake system if you wish to switch
to another fluid brand.
CAUTION*: Brake fluid may cause irrita-
tion. Avoid contact with skin or eyes. In
case of contact, flush thoroughly with
water and call a doctor if your eyes
were exposed.