Chain Adjustment - Husqvarna TE125 2011 Caracteristicas - Uso - Mantenimiento

CHAIN ADJUSTMENT

Chain should be checked, adjusted and lubricated as
per the Maintenance Chart to ensure safety and prevent
excessive wear. If the chain becomes badly worn or is
poorly adjusted (i.e., if it is too loose or too taut), it could
escape from sprocket or break.
1
Make sure that the chain features a slack (A) measuring
approximately 0.47 in., as shown in the nameplate (1)
on chain cover.
If it is not, proceed as follows:
- on the right side, with a 0.98 in. Allen wrench, loosen
the locking nut (2) of the wheel axle;
- adjust the linkages (3) on both sides of the swinging
arm using a 0.24 in. Allen wrench;
- make sure the wheel axle is properly aligned using the
graduated scale (4) for reference;
- the operation done, tighten the wheel axle locking nut
(2).
After adjustment, always make sure that chain has a
slack of 0.47 in.
4
3
2
EN - 29