Starting The Engine - Husqvarna TE125 2011 Caracteristicas - Uso - Mantenimiento

STARTING THE ENGINE

With cold engine, i.e., after the motorcycle has not
been used for a while or in low ambient temperatures,
operate in the following manner:
1) turn the key (1) to set the ignition switch to ON
position;
2) make sure the fuel cock (A) is in the open position
("ON").
3) pull the starter lever (2);
4) pull the clutch lever (3);
5) shift gear pedal (4) to neutral position then release
the clutch control lever;
6) check that the button (5) is in the out position, then
press the start button (6). Bring the starter lever (2)
back to its original position as soon as the motor
can idle. When starting with an already warmed up
engine DO NOT USE the starter. When a cold engine
has just been started, do not increase revs, to en-
sure an adequate oil warm-up and circulation.
EN - 18
1
ON
A
2
3
N
4
5
6