Zhermack SAND Manual De Instrucciones página 128

7.3.1 SAND S24R recycle switch
25
3
Grey
26
9
Figure
USING THE SAND S23
7.4
The SAND S23 sandblasting equipment is used in exactly the same way as the SAND S24. Therefore,
when using the SAND S23 follow the instructions given in section 7.3, bearing in mind that this model
is supplied with a single 60/110 µm tank.
USING THE SAND S25, SAND S25R
7.5
Before using the SAND S25 or SAND S25R sandblasting equipment it is recommended
that you always apply an adhesive protective sheet on the inner side of the glass
hatch to protect it against wear and maintain optimum visibility over time.
Sticker
b
Lue
Sticker
r
Sticker
b
LaCK
10
Figure
Always observe the micron-relevant information given on the tanks. Do not invert the
sand types as this will damage the nozzles and cause sand outflow difficulties too.
It is recommended that you do not employ previously used sand as this will
definitely cause clogging of the nozzles.
128 of 176
Fig. 9: To use the sand recycle nozzle (26) set selector
0
switch (25) to position 3 (grey adhesive); proceed as
illustrated in the previous diagram.
1
Blue
2
- Black
Fig. 10: Fill the sand tanks by undoing the knobs (1) and
removing the corresponding lids (2) relative to the:
ed
• cylinder (3) with the Blue sticker for 60/110 µm sands
(do not exceed the level marker on the inside of the
tank itself )
• cylinder (3I) with the Red sticker for 26/60 µm sands
(do not exceed the level of the sand-splitter crown).
• cylinder (3II) with the Black sticker for 110/250 µm
sands (do not exceed the level of the sand-splitter
crown).
MAINTENANCE AND USE MANUAL
EN
Check that the quantity of sand in the
sandblasting chamber conical tank is
sufficient to prevent the creation of
vortices that impede regular sand outflow.
SAND S 23 / S 24 / S 24 R / S 25 / S 25 R