Zhermack SAND Manual De Instrucciones página 121

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

MAINTENANCE AND USE MANUAL
Should it be necessary to move the sandblasting equipment proceed as follows:
1. Disconnect the equipment from the mains power supply.
2. Empty the contents of the cylinders (see Chap. 8), remove the light bulb, disconnect the compressed
air intake pipe and the elbow and (where present) the aspirator coupling.
3. Gather all its accessories together.
4. Hold the bottom of the equipment, making sure that it is always kept vertical. Proceed cautiously,
bearing in mind the size and weight of the unit (see section 4.2.3), so as to prevent any accidents that
might be caused by failure to evaluate such factors.
5. Pack the equipment in its original box or, if this is not possible, take all the necessary precautions to
protect the equipment against knocks or drops, in that the goods are transported at the owner's risk.
Failure to observe the above exonerates the Manufacturer from any liability
concerning equipment malfunction and consequently renders the Warranty null
and void.
When shipping/delivering the equipment to your Authorised Servicing Centre
always enclose a copy of the purchase document and a copy of the properly
compiled ID form.
If the unit is to be transported by courier, the postal service or rail it is
recommended such shipments be insured.
When disposing of the packaging materials the user must comply with the standards in force in his/
her country regarding the following materials:
• Wood/paper: non-polluting materials, but must be recycled properly.
• Polystyrene/plastic: pollutants which must not be burnt (toxic fumes) nor dispersed into the
environment, but disposed of in compliance with the standards in force in the country of use.
If the equipment is to be dismantled the user must, in compliance with EC directives and the laws in
force in the country of use, effect elimination and recycling of the following materials:
• Plastic and glass parts, insulated electrical wiring, rubber parts.
• There are no toxic or corrosive parts.
This product must not be disposed of as household waste but rather, when no
longer used, must be collected separately according to UE Directive 2012/19.
SAND S 23 / S 24 / S 24 R / S 25 / S 25 R
EN
TRANSPORT AND MOUNTING
ELIMINATION / DISMANTLING
5.3
5.4
121 of 176

Publicidad

Tabla de contenido
loading

Tabla de contenido