Pre-Installation Checklist - Look 795 Manual De Instrucciones

EN

Pre-installation checklist :

Your frame is now supplied with:
• its fork and Head Fit 3 headset pre-set in the factory
• brake and derailleur cable sheaths routed for a mechanical groupset.
• on the Aerolight model: the front brake callipers on the fork and rear units on the frame.
Should you nevertheless need to remove and refit these components, e.g. for maintenance,
this is how to do it:
COMPLETE 795 ROUTING
Sheath fitting sequence :
Mechanical
Rear derailleur
Front derailleur
To be fed through AFTER fitting
the bearing seats in the frame and
assembling the fork
Rear brake
Front brake To be fed through AFTER assembling the fork
Head tube front face routing:
There are 4 holes on the front face of the head tube. These 4 holes are used to feed through
the liners, rear brake cable sheath, mechanical and electronic derailleur cable sheaths. The
table below summarises the various configurations available according to routing (mechanical
or electronic).
For a full explanation of the method of feeding mechanical and electronic cable sheaths
through, please refer to:
http://www.lookcycle.com/media/upload/795/795.pdf
22
795 Light and Aerolight routing
DI2
To be fed through WHILE assembling
the headset
To be fed through AFTER fitting
the bearing seats in the frame and
assembling the fork
HEAD TUBE FRONT FACE VIEW :
1
3
795 Aerolight and Light routing
Mechanical
1 Rear derailleur cable sheath (
Ø
2 Rear brake cable sheath (
Ø
3 Plug G ( 7,5mm hole)
Front derailleur cable sheath
4
( Ø 4mm) + Liner + Stop E
WARNING :
This recess is provided solely for the
Shimano connector when a Di2 electronic
groupset is fitted. With a mechanical
groupset this recess must be kept empty
and sealed. Do not put food, tools or any
other object in it as it might drop into the
frame and seriously impair the bike's
performance.
2
4
DI2
Ø 4mm) Rear brake cable sheath (
Ø
5mm) Plug H ( 6mm hole)
Rear/front derailleur wire
Ø Ø
( 2mm) + Plug G ( 7,5mm hole)
Rear/front derailleur wire
( Ø 2 mm) + Plug G ( Ø 7.5 mm hole)
EN
Ø 5mm)
23