Maintenance And Cleaning; Monthly; Troubleshooting; Disassembly - Abicor Binzel WH Instructivo De Servicio

7 Maintenance and cleaning

7 Maintenance and cleaning
Scheduled maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.
WARNING
Danger of crushing
Parts of the body can be crushed between the torch neck and the guide device when aligning the torch neck during
normal operation.
• Keep out of the danger zone.

7.1 Monthly

A monthly basic cleaning is recommended, and necessary in case of extreme working conditions.

8 Troubleshooting

Please observe the attached document "Warranty". In the event of any doubts and/or problems, please contact your retailer
or the manufacturer.
NOTICE
• If the measures described below are not successful, please consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding components, such as the power supply, welding torch
system, coolant recirculator, etc.
Fault
The test block is blocked and does not return
automatically to the basic position
The torch does not fit into the clamping device • Clamping body soiled
Tab. 8 Troubleshooting

9 Disassembly

NOTICE
• Only qualified personnel are permitted to perform work on the device or system.

10 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. To correctly
dispose of the product, it must first be disassembled.
 9 Disassembly on page EN-14
10.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus, almost infinitely
recyclable. The plastic materials used are marked in preparation for sorting and separation of the materials for later
recycling.
10.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These materials must be
stored, transported and disposed of in suitable containers. Please observe the relevant local regulations and disposal
instructions in the safety data sheets specified by the consumables' manufacturer. Contaminated cleaning tools (brushes,
rags, etc.) must also be disposed of in accordance with the information provided by the consumables' manufacturer.
10.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
EN - 14
Cause
• Spring broken
• Test block soiled
Alignment jig
Solution
• Change the spring
• Clean the test block
• Basic cleaning
BAL.0022 • 2019-04-23