Brita PROGUARD Coffee Manual De Instrucciones página 79

Step
Instructions
#
14 Set the bypass position in the pre-filter head to its original value (see step #7)
15 Close the locking handle of the filter head of the PURITY C150 PROGUARD cartridge
Repl acement of PURITY C500 MinUp
Step
Instructions
#
Note: During the cartridge replacement, the coffee machine's water demand can
- only be served by the filtrate that is being stored in PROGUARD Coffee's storage
tank at that this point in time. If necessary, wait a while until the tank has been further filled
Open the locking handle of the filter head of the PURITY C150 PROGUARD cartridge
1
by bringing its two blue handles in an inclined position
2 Open the locking handle of the pre-filter head
Release the remaining pressure from the pre-filter (PURITY C300/C500/C1100 Quell ST or
C50 Fresh):
3 • Open the flush valve of the pre-filter head by pushing the grey slider outwards
• Catch the coming out water with a bucket
• Close the flush valve
4 Pull the pre-filter head off the pre-filter cartridge
5 Insert a new PURITY C500 MinUp cartridge into the pre-filter head
Close the locking handle of the pre-filter head by bringing its two blue handles in a
6
horizontal position
Make sure the bypass position in the pre-filter head is set to 0 %. Take a note of the
7
former setting
Open the flush valve of the pre-filter head and flush 2 bed volumes (1 bed volume equals
8
5.4 litres)
9 Open the locking handle of the pre-filter head
Release the remaining pressure from the PURITY C500 MinUp cartridge:
10 • Open the flush valve to release the remaining pressure
• Close the flush valve, once the pressure has been released
11 Pull the pre-filter head off the PURITY C500 MinUp cartridge
Replacement of the exhausted PURITY C500 MinUp cartridge:
• Open the locking handle of the filter head
12
• Exchange the cartridge
• Close the locking handle of the filter head
13 Insert the pre-filter into the pre-filter head and close the pre-filter head's locking handle
14 Set the bypass position in the pre-filter head to its original value (see step #7)
15 Close the locking handle of the filter head of the PURITY C150 PROGUARD cartridge
Replacement of The PURITY C Pre-Filter (C300/C500/C1100 Quell ST or C50 Fresh)
Step
Instructions
#
Note: During the cartridge replacement, the coffee machine's water demand can
- only be served by the filtrate that is being stored in PROGUARD Coffee's storage
tank at that point in time. If necessary, wait a while until the tank has been further filled
Open the locking handle of the filter head of the PURITY C150 PROGUARD cartridge
1
by bringing its two blue handles in an inclined position
2 Open the locking handle of the pre-filter head
EN
79