End Of Operation - diversey TASKI swingo 1660 Instrucciones Originales De Uso

End of operation

• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Lift the suction nozzle.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but-
ton.
The display lights up; the suction en
gine stops.
• Switch off the machine.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
Removing and cleaning the squeegee
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc-
tion nozzle is released and can be re-
moved from the suction nozzle
holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure op-
timal suction results!
Empty and clean the recovery tank and fresh water tank
• Remove the drain water hose (red) from the holder.
• Put the drain hose into the drainage.
• Press the crushing point (1) of the drain hose.
• Pull the lid off the drain hose and
drain the recovery tank.
1
1
• Proceed in the same way for draining the fresh water tank.
For that purpose, remove the cleaning solution drain hose
(glue) from the holder.
Cleaning the recovery tank and fresh water tank
• Open the tank cover until the support
engages in the tank wall.
• Rinse the recovery tank and the fresh water tank thorough-
-
ly with clean water.
• Remove the dirt sieve (yellow), emp-
ty it and thoroughly rinse it under run-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
Attention:
Clogged suction filters may impair the suc-
tion performance.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hoses back into the holder.
EN
11