Replenishing cleaning solvent
Attention:
The flooring may be damaged when work-
ing without cleaning solution.
Notice:
A rattling noise from the pump indicates an
empty fresh water tank (Flextank).
Attention:
The pump must never run dry for an ex-
tended period.
• The machine must be switched off.
• Open the tank lid.
• Fill water into the fresh water tank (Flextank), see page 81.
• Add the cleaning product using the dosing cup.
• Tip the tank cover back into its original position and press
it down until it locks.
Draining dirty water
Recovery tank full display:
• If the Recovery tank display lights up, the
cleaning program is interrupted, the suction
nozzle is lifted and the suction unit is
switched off.
• Drain the recovery tank, see page 85.
Notice:
In case of frothing in the tank, the recovery
tank display also lights up.
• Drain the recovery tank, see page 85.
End of operation
Manual process
• Press the Brush drive ON/OFF button.
The cleaning solution supply is stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
• Press the Brush drive ON/OFF button.
The display lights up and the brush unit is
stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Press the Suction unit ON/OFF button.
The display lights up and the squeegee is
automatically lifted.
The suction motor is still on for 15 seconds.
Automatic process
• Press the Program start/stop button.
The lateral cleaning unit is stopped, lifted,
and retracted.
The front cleaning unit is lifted.
The cleaning solution supply is stopped.
The brush unit is stopped and lifted.
After 30 seconds, the suction nozzle /
squeegee is lifted.
The suction motor is still on for 15 seconds
until it is automatically switched off.
Removing and cleaning the squeegee
• The machine must be switched off.
• Remove both suction hoses from the squeegee nozzles.
• Compress the position locks. The
suction nozzle is released and can
be removed from the suction nozzle
holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure op-
timal suction results!
Draining and cleaning the recovery and fresh water tank
(Flextank)
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment of the
cleaning solution manufacturer must be
observed.
• The machine must be switched off.
Proceed as follows:
• Open the tank lid.
• Remove the drain water hose from
the holder.
1
• Put the drain hose into the drainage.
• Squeeze the neck (1) of the drain
hose.
• Pull the lid off the drain hose and
drain the recovery tank.
• Lift the fresh water tank (Flextank), put it into the recovery
tank at the lowest point and discharge it.
• Remove the empty fresh water tank (Flextank) from the re-
covery tank and thoroughly rinse it with clean water.
• Thoroughly rinse the recovery tank with clean water.
• Remove the solids filter (yellow) and
thoroughly drain and rinse it under
running water.
EN
85