End Of Operation - diversey Taski swingo 2100µicro Traducción De Las Instrucciones Originales De Uso

End of operation

Manual process
• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Continue to drive a few meters.
Notice:
Very important for TASKI contact pads!
• Press the Brush drive ON/OFF but-
ton.
The display lights up and the brush
unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Press the Suction unit ON/OFF but-
ton.
The display lights up and the squee-
gee is automatically lifted.
The suction engine continues run-
ning for 15 seconds to prevent drip-
ping.
Automatic process
• Press the Program ON/OFF button.
The cleaning solution supply is
stopped.
• The brush unit is stopped and lifted.
• After 30 seconds, the suction nozzle / squeegee is lifted.
• The suction motor is still on for 15 seconds until it is auto-
matically switched off.
Removing and cleaning the suction nozzle
• The machine must be switched off.
• Press the spring lock [1] together and
2
remove the suction hose [2].
1
• Compress the position locks. The
squeegee is released and can be re-
moved from the squeegee holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure optimal suc-
tion results!
Empty and clean the recovery tank and fresh
water tank
Caution:
Drain water or cleaning solution must be disposed
of in compliance with the national regulations.
Caution:
When draining the recovery tank, the regulations of
the detergent supplier regarding personal protec-
tive equipment must be observed.
Empty recovery tank
• Remove the drain water hose from
the holder.
• Put the drain hose into the drainage.
• Press the crushing point (1) of the
1
drain hose.
• Pull the lid off the drain hose and
drain the recovery tank.
Empty fresh water tank
• Take the fresh water tank drain hose
from the holder.
• Put the drain hose into the drainage.
• Take the cover off the drain hose and
empty the fresh water tank.
Notice:
In order to accelerate the emptying of the fresh wa-
ter tank, you can additionally remove the fresh wa-
ter tank filter.
• Rinse the recovery tank and the fresh water tank thorough-
ly with clean water.
• Remove the solids filter (yellow) and
empty it.
• Rinse the filter thoroughly under run-
ning water.
• Remove the suction filter (yellow)
and wipe off dirt using a cloth or a soft
brush.
Caution:
Clogged suction filters may impair the suction per-
formance.
Caution:
Clogged intake filters may reduce the amount of
cleaning solution.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hose into the holder.
13