Diamond DBT102/L Manual De Instrucciones página 35

Hard Temperature Blast Chilling cycle
1
GB
Select blast chilling by pressing key
and
message
again: the
Insert the core probe into the product. Start the
cycle by pressing the
time decreasing starting from 90' can be seen.
During the blast chilling cycle by pressing
key temperature detected by the core probe can
be visualized; by pressing that same key for 5
seconds temperature detected by chamber probe
ENGLISH
2
led lights turn on, the display shows
. Press key
display shows the
and led light
key. On the display
can be visualized. If
can be seen on the display (alternated to the time
value) that means that at the end of maximum
90'', the product temperature is not less than set
+3°C.
As soon as product temperature is lower than
+3°C the blast chilling cycle is considered as
completed and a preserving cycle is automatically
until
The
an intermittent sound and switch-on of LED
confirm the correct conclusion of the cycle.
The
message
will blink.
messages on the display, indicates the end of the
cycle beyond the maximum time equal to 90
minutes. Press
taken. By pressing
by cell probe can be visualized.
Press
10
message on the display,
appearance of the
and
to detect the effective time
key temperature detected
to conclude the preservation cycle.
message
alternating