Diamond DBT102/L Manual De Instrucciones página 41

Cleaning the condenser
Clean the condenser periodically.
!
As the fins of the condenser are very sharp,
always wear protective gloves for the next
phases. Use protective masks and glasses in the
presence of dust.

Whenever the condenser has a deposit of
dust in correspondence with the fins, this can be
removed using a suction device or with a brush
applied, using a vertical movement along the
GB
direction of the fins.
!
No other instruments must be used, which
may deform the fins and therefore the efficiency of
the appliance.
To clean, proceed as follows:
1. Open the door (A) of the appliance.
2. Remove the lower panel (B) from the
technical compartment: to do this, remove
the screw fasteners (C).
3. It is now possible to clean the finned part
of the condenser (D) using suitable tools
and protection devices.
4. After cleaning, close the control panel and
fix it with the screws removed beforehand.
Fuse replacement and thermal relay rearm

The fuses (A) and the thermal relay (B) are
in the upper part of the blast chiller. To access
these just open the control panel (C) by loosening
the two screws (D) positioned in the lower part of
the control panel and rotating it upwards. After
opening, make sure that it does not fall back
down.
ENGLISH
C
B
C
D
C
D
Rearm the heat relay using
the grey button
16
C A
A
B