Electric Power Supply Connection - Diamond DBT102/L Manual De Instrucciones

On delivery, check that the packaging is intact and
has not undergone
transportation.
The transportation company must be notified of
any damage immediately.
The appliance must be unpacked as soon as
possible to check that it is intact and undamaged.
Do not cut the cardboard with sharp tools so as
not to damage to the steel panels underneath.
Pull the cardboard packaging upwards.
After having unpacked the appliance, check that
the features correspond to those requested in the
order;
8.2. Installation
All the installation phases must be considered,
from the moment of creation of the general plan.
The installation area must be equipped with all
power supply and production residue drainage
connections and must be suitably lit and respect
current laws regarding hygiene and sanitary
requirements.

The performance
guaranteed with a room temperature of 32°C. A
higher temperature can
performance and, in more serious cases, cause
the appliance's protections to start up.
Therefore, consider the
conditions that can be reached in that position
before making a choice.
Level the appliance by acting on the individual
feet.
!
This appliance can only be installed and
operate in rooms which
ventilated, in order to guarantee correct operation.
8.3.

Electric Power Supply Connection

Connection must be carried out by authorised and
qualified staff, respecting
regarding the subject and using appropriate
prescribed material.

Before connecting the appliance to the
electric mains, check that the voltage and the
frequency correspond to the data stated on the
registration plate applied on the rear of the
appliance.
any damage during
of the appliance is
compromise its
most critical room
are permanently
the current laws
Contact the dealer immediately if there are any
anomalies.
!
Packaging
polystyrene foam, staples ...) must not be left
within reach of children.
Remove the protective PVC film from the internal
and external walls, avoiding the use of metal
tools.

Connect and leave for a certain period of
time (at least 2
functioning. During transport it is probable that the
compressor lubricant
refrigerant circuit blocking the capillary: as a
consequence the appliance will function for a
certain period of time without producing cold until
the oil has returned to the
!
ATTENTION: the appliance requires the
minimum functioning spaces, as shown in the
attachments.
The defrosting water and the water that forms at
the bottom of the refrigerating compartment
during operation or during periodical internal
cleaning must be drained through a prearranged
hose with a minimum diameter 3/4" connected to
the hose at the bottom of the chiller.
A drain trap should also be guaranteed. The drain
must be in compliance with Standards in force.

The appliance is supplied with an operating
voltage of 400V 3+N~ 50Hz. On request, it is
possible to have
voltages.
!
Before connection, ensure the presence of a
relevant differential switch with adequate power in
the mains power supply, upstream from the
appliance, in order to protect the appliance from
overloads or short circuits
19
ENGLISH
elements (nylon bags,
hours) before checking
oil has entered the
compressor.
appliances with different
GB