Astralpool VICTORIA PLUS SILENT VS Manual De Instrucciones página 16

2.3.5 SETPOINTS. CONFIGURATION OF SETPOINTS
1. Enter the SETPOINT option in the Settings Menu to display/modify the values assigned to the Setpoint
Units. The Setpoint Unit selected will flash.
2. Use the Up and Down Arrow Buttons (
Unit. There are 3 Setpoint Unit modes that can be configured:
• Low Setpoint: Low rpm or % operating capacity of the pump (depending on the unit configured. See
Section 2.3.4, SETPOINT UNITS). Minimum value.
• Medium Setpoint: Medium rpm or % operating capacity of the pump (depending on the unit configured.
See Section 2.3.4, SETPOINT UNITS). Intermediate value.
• High Setpoint: High rpm or % operating capacity of the pump (depending on the unit configured. See
Section 2.3.4, SETPOINT UNITS). Maximum value.
The operating mode speed will be incremental starting from the Low Setpoint up to the High Set-
point, in other words, the Medium Setpoint value cannot be higher than the High Setpoint value or
lower than the Low Setpoint value. The following condition must therefore always be fulfilled:
High Setpoint Value ≥ Medium Setpoint Value ≥ Low Setpoint Value.
3. Press button (Enter) to confirm the value assigned to the Setpoint Unit. Once confirmed, it will go on
5
to the next Setpoint Unit. Once the last Setpoint Unit value has been entered, it will return to the option
in the Settings Menu.
CLOCK DAY UNITS SETPOINT SET SETTING VIEW TIMER EXPERT
SETTINGS
Go back without making changes
Go back to the Settings Menu
16
) to increase or decrease the value assigned to the Setpoint
10
Setpoint Mode Icon Value assigned to Setpoint Mode
SETTINGS
Confirm
HMI VICTORIA PLUS SILENT VS CONTROL PANEL -
Setpoint Mode Unit
SETPOINT
Increase or decrease setpoint mode
value
See next page
INSTRUCTION MANUAL