Manual Mode - Astralpool VICTORIA PLUS SILENT VS Manual De Instrucciones

2. PUMP OPERATING MODES
The pump can work in MANUAL Mode or AUTO Mode. To stop it from running in MANUAL or AUTO Mode
put it back in STANDBY Mode, by pressing button
In STANDBY Mode, the pump will neither run nor will the auto-configuration in AUTO Mode be enabled.
Whenever the pump is started up (in MANUAL or AUTO Mode) from the STANDBY Mode, it will self-prime
for 30 seconds at a speed of 2,850 rpm by default before starting up again. The default self-priming time and
speed can be adjusted, and can be disabled from the EXPERT settings menu (see Section 2.3.9). While it is
self-priming, the speed reading of the mode selected will flash on and off until the process has been completed.
START-UP IN MANUAL MODE. SELF-PRIMING:
MANUAL
TUE
Flashes while self-priming

2.1 MANUAL MODE

In MANUAL Mode, the pump can be manually switch on or off and the operating speed adjusted to the desired
setting.
To stop the pump from running in MANUAL Mode, press button
STANDBY Mode.
In MANUAL Mode, a Setpoint Speed can be selected (see Section 2.1.1) or the speed can be set manually
(see Section 2.1.2).
MANUAL MODE SCREEN:
Operating mode:
MANUAL Mode on
Setpoint Speed icon (Only
displayed if on)
Day of the week
6
(On/Off).
1
®
rpm
®
MANUAL
TUE
HMI VICTORIA PLUS SILENT VS CONTROL PANEL -
®
MANUAL
rpm
TUE
(On/Off) so that it goes back into
1
Operating unit
rpm
Operating speed
INSTRUCTION MANUAL