Pump Start-Up - Astralpool VICTORIA PLUS SILENT VS Manual De Instrucciones

1. PUMP START-UP

Ensure that the pump is plugged in. When plugged in for the first time, it goes into STANDBY Mode and the
message "OFF" is displayed on the screen for 2 minutes.
Every time the pump is unplugged and then plugged back in, the pump will start in the same mode and with
the same configuration as the last time before it was unplugged.
In STANDBY Mode, press button
Mode will be displayed on the screen. As there is no initial auto-configuration, the pump will not start until the
AUTO Mode is configured or the MANUAL Mode used.
When the pump is on in any mode, pressing button
In STANDBY Mode, the pump will neither run nor will the auto-configuration in AUTO Mode be enabled.
If started up on successive occasions, the pump will switch on in the same mode (MANUAL or AUTO) and with
the same configuration as the last time it was switch off, even if unplugged from the mains.
If there is a power cut or if the pump is unplugged while it is running, it will go back to the same
operating mode once the power supply is back.
SEQUENCE OF THE FIRST START-UP
1 2
4
Button 1
On/Off
HMI VICTORIA PLUS SILENT VS CONTROL PANEL -
(On/off) to switch the pump on. The first time it is started up, AUTO
1
(On/off )will put the pump into STANDBY Mode.
1
®
®
INSTRUCTION MANUAL
®
®
AUTO
rpm
MON
1 2 3 4 5 6 7 8 9 10 11
13 14 15 16 17 18 19 20 21 22 23 24
3
Once the 2
minutes have
elapsed, it
will go into
STANDBY
MODE
5
AUTO MODE
12
Screen
5