How To Use The Control Panel; Control Keys - Astralpool VICTORIA PLUS SILENT VS Manual De Instrucciones

HOW TO USE THE CONTROL PANEL

The Victoria Plus Silent VS variable speed pump has a control panel for switching the pump on and
off, and for adjusting and displaying the pump's settings and configuration.

CONTROL KEYS:

On/Off: Press the button to switch the pump on or off. The pump will always start in the same mode and
1
with the same configuration as when it was last switched off.
When the off button is pressed, the message "OFF" will be displayed on the screen for 2 minutes.
Auto Mode: Press the button so that the pump connects and disconnects in AUTO Mode at the setpoint
2
Times and Speeds.
Settings: Press the button to enter the Settings Menu. The Settings Menu can be accessed both when
3
the pump is on or off, provided it is plugged in.
Exit: In the Settings Menu, press the button to exit without saving your changes. Every press of the button
4
will go back one step in the Settings Menu.
Enter: In the Settings Menu, press the button to enter the option selected or to accept/save changes
5
made to the settings.
Setpoint Mode. Low Speed: Press the button so that the pump runs or starts up at Low Speed (by
6
default, 1,400 rpm).
Setpoint Mode. Medium speed: Press the button so that the pump runs or starts up at Medium Speed
7
(by default, 2,100 rpm).
Setpoint Mode. High speed: Press the button so that the pump runs or starts up at High Speed (by
8
default, 2,750 rpm).
Setpoint Mode. Turbo Speed: Press the button so that the pump runs or starts up in Manual Mode at
9
Turbo Speed. This mode is used for self-priming, fast cleaning, etc. (by default 3,025 rpm). The Manual
Mode at Turbo Speed lasts a set time that once over will automatically go into Manual Mode at High
Speed.
Arrow buttons: Browsing, selection and settings buttons.
10
Up arrow: In the
option. If you wish to increase the value selected without stopping, keep the button pressed down
for more than 3 seconds and release it when the desired value has been reached.
This arrow also starts the pump in
Mode
Down arrow: In the
the previous option. If you wish to decrease the value selected without stopping, keep the button
pressed down for more than 3 seconds and release it when the desired value has been reached.
This arrow also starts the pump in
Mode
Left arrow: This arrow scrolls through the options on the left of the
the options in the
Right arrow: This arrow scrolls through the options on the right of the
the options in the
4
Settings Menu
, this arrow increases the value of the setting selected or goes on to the next
and increases the running speed.
Settings Menu
, this arrow decreases the value of the setting selected or goes back to
and decreases the running speed.
Settings Menu
Settings Menu
Manual Mode
when it is in
Manual Mode
when it is in
Settings Menu
.
Settings Menu
.
HMI VICTORIA PLUS SILENT VS CONTROL PANEL -
Standby Mode Auto
or in
Standby Mode Auto
or in
or goes forward through
or goes backward through
INSTRUCTION MANUAL