• See page 58 on charging, recording and playing time.
• When your camcorder
is on, you can check the approximate amount ofremaining
battery power witb the
remaining battery indicator
at tbe upper left on the LCD screen.
To remove the battery
pack
Retract the viewfinder and close the LCD screen. Slide the BATT (battery) release lever (_)
and remove the battery pack @.
To use a wall outlet
(wall socket)
as a power
source
Make
the same connections
as "Step 1: Charging
the batter},
pack."
Notes on the battery pack and the A( Adaptor
• When you remove the battery pack or disconnect
the AC Adaptor, retract the viewfinder and close the
LCD screen, then make sure that the _
(Movie) lamp/l_
(Photo) lamp (p. 15)/ACCESS lamps (p. 13)/
access lamp(p. 44) are turned off
• Do not short circuit the DC plug of the AC Adaptor or battery terminal with any metallic objects. This
may cause a malti.mction.
• In the defhult setting, the power turns offautomatically
if you leave your camcorder without any
operation
tbr approximately
5 minutes, to save battery power ([A.SHUT OFF]).
You can charge th e battery pack in any countries!regi0ns using the AC Adaptor supplied
with your camcorder wifllin file AC!00 V- 240 v, 50 Hz!60 Hz range •
- Do not use an electronic voItage transformer.