Connecting The Suction Device; Connecting The Suction Tube - Sirona inLab MC X5 Instrucciones De Uso

4 Transportation and installation
4.4 Connecting the suction device
16
4.4

Connecting the suction device

4.4.1

Connecting the suction tube

1. Connect one end of the suction tube to the available connection point
on the suction device. The connection point is located on the top side
next to the control panel with the suction power controller.
2. Connect the other end of the tube to the socket (A) on the rear side
A
of the processing machine.
or
Connect the other end of the tube to the rear side of the milling
➢
unit.
Notes on the suction tube:
The suction tube is supplied at a length of approx. 2.40 m (inLab MC X5)
or 2.0 m (CEREC MC/MC X/MC XL Premium Package). When
connecting the suction device to the unit, please ensure that no sharp
bends occur over the full length of the suction tube.
Reduce the length of the tube according to your requirements and your
installation location. Note that suction power drops along the length of the
tube. You obtain decent suction power if the suction device is placed
immediately below the machine and you have a tube length of 1.2 m or
less.
Operating Instructions Suction devices for inLab MC X5 and
Sirona Dental Systems GmbH
64 98 609 D3608
D3608.201.02.02.02 11.2015