Vollrath SLM300/S Manual Del Operador página 7

SAFE BLADE REMOVAL TOOL
1. Unplug the slicer from the electrical outlet.
2. Remove the blade guard cover.
3. Clean the front side of the blade. See "Clean the Slicer" on page 6.
4. Remove the sharpener.
5. Rotate the blade so that the screw holes are parallel to the base of
the slicer.
6. Place the safe blade removal tool on the blade and align the two
knobs on the tool with the holes in the blade.
Tip: Rotate the tool so the warning label is at the top of the tool and
the notch fits around the bump out of the blade guard.
7. Tighten the knobs to secure the tool to the blade.
8. Remove the screws that fasten the blade to the slicer.
9. Lift the safe blade removal tool to remove the blade.
10.Use a brush to clean any debris from the area where the blade
attaches to the slicer body.
11.Reverse the procedure to reinstall the blade. Verify the blade is
installed flat against the pulley.
12.Plug the slicer into the electrical outlet.
Heavy-Duty Electric Slicers Operator's Manual
MAINTENANCE
Schedule
Procedure
Inspect the slicer before each use
Sharpen the blade
Clean and sanitize the slicer
Lubricate the gauge plate slide
Lubricate the carriage slide
Sharpen the Blade
Sharpen the blade daily or any time that cutting becomes difficult or
produces a large amount of waste. The slicer should be treated as a
knife. If it is not adequately sharpened, the slicing results will be poor
and the machine will be overloaded.
WARNING
Cut and Amputation Hazard
The blade on this commercial slicer is extremely sharp. Severe
injury can occur if care is not used when using or cleaning this
product. Only trained personnel should operate equipment or
perform maintenance. To reduce the risk of injury, the use of a
cut resistant glove(s) is recommended when cleaning this
equipment.
NOTICE: Use the integrated sharpener to sharpen the blade. Do not
remove the blade to sharpen.
1. Turn the index control to the zero (0) position.
2. Press and release the OFF (O) button.
3. Unplug the slicer from the electrical outlet.
4. Clean the blade to remove any grease or food.
5. Lift the sharpener and rotate it 180° counter clockwise. Position the
sharpener so the blade is between the sharpening stones.
6. Plug the slicer into the electrical outlet.
7. Press and release the ON (—) button.
8. Press and hold the sharpening stone button. Let the blade rotate
against the sharpening stone for 30-40 seconds. Release the button.
Correctly sharpening the blade should produce sparks. See the
Troubleshooting section if sharpening does not produce sparks.
Daily Monthly
X
X
X
X
X
7