Adjusting The Parking Brakes; Changing Pneumatic Tyres - Vermeiren Trigo S Manual De Instalación

3.2.11 Adjusting the parking brakes

Depending on the diameter of the rear wheels and their position, the brakes can be adjusted
accordingly. The following instructions apply to both the push-pull brakes and the sports brakes.
1. Release the brake, see user manual.
2. Loosen the two screws (34) connecting the brake to
the frame.
3. Slide the brake forwards/backwards in the slot until
the desired position.
4. Firmly retighten both screws.
5. Verify if the brake is working properly; the wheel is
blocked, but the brake can still be operated easily.
If this is not the case, repeat the steps above until
the brake is adjusted well.
6. Repeat for the second parking brake. Make sure
that both brakes are adjusted identically.
3.3

Changing pneumatic tyres

CAUTION
•
Make sure all air is released from the tyre, before removing it.
•
Make sure that no body parts, the inner tube nor any other objects are pinched between tyre
and rim.
•
Make sure all screws are firmly secured by hand before driving with the wheelchair.
•
Make sure that the pressure is correct, see the pressure indication on the tyres.
•
Inflate the tyre using inflating equipment which complies to regulations and with a pressure
indication in "bar".
•
Only use replacement parts approved by Vermeiren.
To change the tyre or inner tube, proceed as follows:
1. Let all the air out of the inner tube.
2. Insert a tyre lever between de tyre and the rim.
3. Gently push the tyre lever downwards. This will pull the tyre over the edge of the rim.
4. Move the lever along the rim so the tyre pops out.
5. Carefully remove the tyre from the rim and remove the tube.
Place the rim belt in position over the air valve before inserting it into the rim. The
rim belt can now be pulled over easily. Check that all spoke heads are covered (a
rim belt is not required in the case of a plastic rim).
Push the tyre over the edge of the rim, starting behind the air valve. Inflate the tube
slightly until it is round, and place it inside the tyre.
Risk of injuries and damage
11
Trigo S, Trigo T
2019-11
Assembly and adjustments
34
EN
NL
PL
CS