Troubleshooting; Technical Data - Oase FILTOCLEAR 800 Garantia, Instructivo De Seguridad Y De Operaciones

Filtoclear
Dimensions in inches
(LxWxH)
Inlet and outlet
Filter volume in gallon
Crystalline filter surface
Integrated UVC clarifier
Nominal voltage UVC
Lamp components UVC
Cable length
Weight
18

Troubleshooting

Fault
Possible causes
Water not
• Unit not been used
getting clear
for long
• Inappropriate pump
capacity
• Water is extremely
dirty
• Fish and animal
population too large
• Filter sponges are
dirty
• Quartz tube is dirty
UVC lamp
• Mains plug of Filtoclear
indicator is
UVC not connected
not on
• Defective UVC lamp
• Faulty connection
• Lamp has no UVC
output
• Protective tube not
fitted
• Filtoclear UVC over-
heating
No water
• Function switch set
discharge
to "Clean"
from pond inlet
• Mains plug of pump
not connected
• Pond inlet blocked

Technical data

800
14,96x14,96x12,2 14,96x14,96x17
¾" to 1½"
1,3
57 ft²
9 W
120V/60Hz
9W UV-C, G23
15 ft
11 lbs.
English
Measures
• Full biological cleaning effectiveness
is only reached after a few weeks.
• Reset pump capacity
• Remove algae and leaves from
the pond, change the water
• Guideline: approx. 2 feet fish length
to every 265 gal of pond water
• Clean the filter sponges
• Remove the Filtoclear UVC and
clean the quartz tube
• Connect the mains plug of the
Filtoclear UVC
• Replace the UVC lamp
• Check the electrical connection
• The lamp should be replaced after
approx. 8,000 hours of operation
• See Replace UVC lamp
• After cooling down, UVC
switched on automatically
• Reset function switch to "Filter"
• Connect the mains plug of the
pump
• Clean pond inlet
1.600
14,96x14,96x21,6 14,96x14,96x26,4
¾" to 1½"
2,4
113 ft²
9 W
120V/60Hz
9W UV-C, G23 9W UV-C, G23
15 ft
12 lbs.
3.000
¾" to 1½" ¾" to 1½"
3,7
170 ft²
9 W
120V/60Hz 120V/60Hz
9W UV-C, G23
15 ft
13 lbs.
4.000
4,5
225 ft²
9 W
15 ft
14 lbs.