CYBEX gold SIRONA S Manual Del Propietário página 69

INSTALLING CHILD RESTRAINT WITH LAP/SHOULDER BELT
8. On buckle side, first lift up on shoulder belt to
remove slack in lap belt. Then remove slack
from shoulder belt on opposite side.
At this point, only remove slack from vehicle
belts, being careful not to overtighten them.
Belt Tensioner will tighten system fully. If
you have previously installed Restraint using
LATCH, make sure LATCH Strap lies flat on
bottom of the Base. See "To Store" section on
page 37.
Some vehicle lap/shoulder belts have a plastic
button or extra fold of webbing on the belt.
Do not allow these to interfere with belt
routing through Belt Tensioner. If they
interfere:
a. Use LATCH if within the weight limit, or
b. Move the child restraint to a different
location.
(PREFERRED METHOD)
8
69