Twistorr 304 Fs On-Board Controller Installation; Bottom Mounting - Agilent Technologies TwisTorr 304 FS Serie Manual De Istrucciones

17 Technical Information

TwisTorr 304 FS On-board Controller Installation

TwisTorr 304 FS On-board Controller Installation

The controller can be mounted in two position:


To install the controller execute the following procedures.

Bottom Mounting

See the following figure.
1
2
3
4
5
6
7
288/304
bottom mounting (as per the complete system)
side mounting.
Turn the pump upside-down;
Screw the 4 fixing studs (provided with the accessories bag) in
the holes on the bottom of pump;
Place the controller on the studs aligning the 4 rubber holes on
the top of the controller case;
Press the controller towards the pump;
Turn the pump again;
Plug the line cord and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
TwisTorr 304 FS User Manual / 87-901-027-01(B)