Monitorr Installation On The Network And On The Main Pc - Agilent Technologies Turbo-V 2K-G Serie Manual De Instrucciones

Operation
At predefined intervals, the Monitorr will also acquire the data
related to the vibration spectrums, power and temperature in
addition to other data detected by the Turbo controller. All the data
must be transferred to a PC (by means of the "File Download"
program) where are stored and where can be analyzed by Agilent's
specialised person-nel.
Maintenance
The MoniTorr card doesn't require any mainte-nance. Any
intervention must be carried out by authorised personnel.
In case of failure, the Agilent Repair Service is available or Advanced
Exchange Service that pro-vides you with a regenerated controller in
replacement of the faulty one.
MoniTorr Installation on the Network
and on the Main PC
The RS-485 interface allows connecting more than one system in
network (up to 32). In this way it is possible to download all the
spectrums data with a single PC through a protocol converter (not
yet available) which operate as a gateway from 485 to 232 link.
The controller provides the serial address of the MoniTorr option.
Every controller must therefore have a different serial address so as
to avoid conflicts on the network. Every controller has "0" default
serial address. So the user must set the controller's address.
The following figure shows the connection of the MoniTorr to the
RS485 network.
Turbo-V 2K-G Pumping System User Manual / 87-900-968-01
Technical Information
MoniTorr
(G)
17
331/372